If you are having trouble locating the dashboard light control switch, refer to the owner’s manual for further assistance.
If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic. Turn off your headlights and vehicle when you’re done.
Refer to your owner’s manual if you have trouble locating the fuse boxes or the dashboard light fuse. If you have more than one fuse labeled “lights,” you’ll need to check them all.
If you don’t have a fuse puller, you can use a pair of needle-nose pliers to remove the fuse. Make sure your vehicle is off and the key is out of the ignition before pulling any fuses!
Replace the fuse box cover, then turn on your vehicle and headlights to see if the dashboard lights are working. Note that using a fuse with a different amperage could create an electrical hazard.
On some vehicles, you may have to remove the radio to access the trim. Be sure to keep track of all the screws and set them aside in a safe place so you can replace them when you’re done.
The faceplate is secured with spring-clip fasteners, which should disengage fairly easily. Avoid using a screwdriver to pry up the faceplate, as it can easily mark or damage the dash.
Use a small screwdriver to pry out the bulbs if you aren’t able to remove them by hand. Older vehicles have standard bulbs, but newer vehicles use LEDs to light the dash. [11] X Expert Source Hovig ManouchekianAuto Repair & Design Specialist Expert Interview. 23 February 2021. Unfortunately, if your vehicle has LED bulbs, you won’t be able to replace them yourself. Take your vehicle to a repair shop to get the entire instrument panel replaced.
It’s best to replace all of the lightbulbs at one time, even if some of them are working properly. This can prevent you from having to tear apart the dash again in the future if another bulb goes out.
When you’re done, start your vehicle, turn on the headlights, and see if your dashboard lights come on. If they don’t, head over to a repair shop to have a certified mechanic diagnose and fix the problem.
