You can order a new switch online or buy one from your local appliance store. You could also hire a repairman to replace it for you.
Don’t try to handle the water in the machine until it’s unplugged. You probably don’t need to worry, but it’s best to be safe.
This is typically the easiest way to remove water if you’re new to home repairs. Place your clothes in a large container, the sink, or the bathtub. They’ll likely be sopping wet, so they can damage some surfaces, such as your flooring. You could also disconnect the hose and place the end in a bucket to drain the water. Make sure the bucket and hose are lower than the port in the washing machine so it drains.
Typically, top loading washers are more likely to be accessible from the front. Check your owner’s manual to locate the machine’s pump.
These screws are typically at the corners of the panel near the bottom of the machine. Some washers have a small black panel or flap that allows you to access the pump without removing the entire panel.
The panel will likely feel heavy, so make sure you have a good grip on it.
If you don’t notice any damage, you might have a clog or another damaged part.
If you have your owner’s manual, it should have a picture of the pump that you can use as a reference.
If your pump is clear, you may be able to see the clog through the plastic. Water may leak out of the hose or the pump when you disconnect them. You can attach a clump to the drain hose where it connects to the washer so the water doesn’t leak while you check the hose and pump. Look for hose clamps at your local home improvement store.
If you’re not sure what the pump is supposed to look like, this can be tricky. You can use the illustration of the pump in your manual as a reference, but it may be best to call in a professional.
If you’ve been hearing a weird sound during your previous washes, it’s safe to assume something could be wrong with the pump. Call a plumber or handyman to find out for sure.
Go slowly so that you don’t break up the clog or damage the pump. It’s possible that a clog inside your pump is wrapped around the spinning mechanism inside the pump. It’s usually easier to remove a clog from the hose. It should slide out easily if you just pull.
Turning the pulley will help you avoid damaging the pump. If turning your pump counterclockwise isn’t helping, try turning it clockwise instead.
After you remove the clog, water that was stuck in the pipe may pour out into the bucket.
Make sure that you haven’t created any kinks in the hose while you were working on it. If there are kinks, it could prevent your washer from draining.
If it’s still not draining, it’s possible there’s a clog you can’t get to or that the pump is damaged. It’s best to get a plumber or handyman to look at it.
You can buy a replacement pump online or at an appliance store. Replacing a pump correctly can be tricky, so if you’re unsure, you may want to hire a professional. [18] X Research source }}
If your belt looks damaged, you may want to replace it. You can get a new belt online or at an appliance store. To install it, simply loop the new belt around the motor and the bottom of the pump.
You might want to save the screws in case you need them to install the new pump. However, your new pump should come with screws.
The new pump should line up exactly with the existing screw holes in your washing machine. If it doesn’t, check that you got the right pump for your washing machine.
Some pumps attach to an additional pipe. If your machine has a second pipe, attach it to the second port on your pump.
Test your pump by turning on your washing machine.
